管外降膜湿润能力的实验研究

doi:10.12034/j.issn.1009-606X.217203

摘要/Abstract

摘要： 在不同进液流量、进液高度、进液孔径、管径和倾斜角下，用图像法测量了光滑圆管外壁液膜湿润长度，研究了各参数对液膜湿润能力的影响. 结果表明，随进液流量增大，液膜湿润能力先增大后稳定在一个固定值. 研究进液高度对湿润能力的影响时需考虑液膜的流型，流型为柱状流时，液膜进液高度对液膜湿润能力的影响较小；流型为柱状?片状流时，随进液高度增大，液膜湿润能力先减小后不变；流型为片状流时，液膜湿润能力达到饱和. 研究进液孔径对湿润能力的影响时需考虑液膜的流型，流型为柱状流时，液膜湿润能力随进液孔径增大先增大后减小，变化幅度较小；流型为柱状?片状流和片状流时，液膜湿润能力随进液孔径增大而减小. 一定流量下，管径越大，液膜湿润表面积越大，湿润能力越差. 受倾斜角度的影响，液膜湿润长度不再沿进液柱对称分布，湿润能力出现下强上弱的分布规律.

关键词: 降膜, 湿润能力, 布液器, 流动, 测量, 层流

Abstract: Influences of various parameters such as liquid inlet flow, feeding height, inlet aperture, diameter of tube and inclined angle on the wetting ability of liquid film were studied. Image processing method was adopted to measure wetting length of liquid film on the plain tube with different parameters. The experimental results showed that with the increase of the flow rate, the wetting ability of the liquid film stays the same after reaching the peak. When the feeding height is investigated, the flow pattern needs to be considered. The effect of feeding height on wetting ability is negligible with the flow pattern of columnar flow. Wetting ability decreases firstly then remains unchanged with increasing feeding height under columnar-sheet flow regime. Shortly after sheet flow, wetting ability reaches saturation. As for increasing the inlet aperture, the flow pattern needs to be considered. Wetting ability increases first and then decreases under columnar flow, but the variation is relatively small. When flow pattern is transformed into columnar-sheet flow or sheet flow, liquid wetting ability will fall. Under the condition of a certain flow rate, the larger the diameter is, the larger the wetting area of the liquid film is, but the worse the wetting ability is. When the experimental tube is not horizontally placed, the change regulation of wetting length is no longer symmetrical with the liquid inlet column, but the lower part is stronger and the upper part is weaker.

Key words: falling film, wetting ability, distributor, flow, measurement, laminar flow

林仕张政庄焜煜刘曦葛周天陈君浛李学来. 管外降膜湿润能力的实验研究[J]. 过程工程学报, 2018, 18(1): 49-56.

Shi LIN Zheng ZHANG Kunyu ZHUANG Xi LIU Zhoutian GE Junhan CHEN Xuelai LI. Experimental Study on the Wetting Ability of Falling Film[J]. Chin. J. Process Eng., 2018, 18(1): 49-56.

参考文献

[1] 何茂刚，王小飞，张颖．制冷用水平管降膜蒸发器的研究进展及新技术[J]．化工学报，2008，59(S2)：23-28．
HE M G，WANG X F，ZHANG Y．Review of prior research and new technology for horizontal-tube falling-film evaporator used in refrigeration[J]．CIESC Journal，2008，59(S2)：23-28．
[2] HONDA H，NOZU S，UCHIMA B．A prediction method for heat transfer during film condensation on horizontal low integral-fin tubes[J]．Nihon Kikai Gakkai Ronbunshu B Hentransactions of the Japan Society of Mechanical Engineers Part B，1986，53(109)：218-225．
[3] ARMBRUSTER R，MITROVIC J．Patterns of falling film flow over horizontal smooth tubes[J]．Begel House Inc，1994，3：275-280．
[4] HU X，JACOBI A M．The intertube falling film：part 1—flow characteristics，mode transitions，and hysteresis[J]．Journal of Heat Transfer，1996，118(3)：616-625．
[5] HU X，JACOBI A M．The intertube falling film：part 2—Mode effects on sensible heat transfer to a falling liquid film[J]．Journal of Heat Transfer，1996，118(3)：626-633．
[6] HU X，JACOBI A M．Departure-site spacing for liquid droplets and jets falling between horizontal circular tubes[J]．Experimental Thermal & Fluid Science，1998，16(4)：322-331．
[7] HAN-SHIK C，WUSIMAN K，SEONG-SOO K，et al．Liquid film falling behaviour on horizontal circular cylinder[J]．Journal of Central South University，2012，19(5)：1353-1358．
[8] WANG X F, JACOBI A M. A thermodynamic basis for predicting falling-film mode transitions[J]. International Journal of Refrigeration, 2014, 43(4):123-132．
[9] MITROVIC J．Flow structures of a liquid film falling on horizontal tubes[J]．Chemical Engineering & Technology，2005，28(6)：684-694．
[10] NUSSELT W．Die oberflachen kondensation des wasser damfes[J]．Z．Ver．Dtsch．Ing，1916(60)：541-546．
[11] ROGERS J T．Laminar falling film flow and heat transfer characteristics on horizontal tubes[J]．Canadian Journal of Chemical Engineering，1981，59(2)：213-222．
[12] ROGERS J T，Goindi S S．Experimental laminar falling film heat transfer coefficients on a large diameter horizontal tube[J]．Canadian Journal of Chemical Engineering，1989，67(4)：560-568．
[13] HOU H，BI Q， MA H，et al．Distribution characteristics of falling film thickness around a horizontal tube[J]．Desalination，2012， 285(3)：393-398．
[14] 许莉，王世昌，王宇新，等．水平管外壁液膜流动状态及其对传热的影响[J]．化工学报，2002，53(6)：555-559．
XU L，WANG S C，WANG Y X，et al．Flowing state of liquid films over horizontal tubes and its influences on heat-transfer characteristic[J]．CIESC Journal，2002，53(6)：555-559．
[15] XU L，WANG S，WANG Y，et al．Flowing state in liquid films over horizontal tubes[J]．Desalination，2013，156(1-3)：101-107．
[16] GSTOEHL D，ROQUES J F，CRISINEL P，et al．Measurement of falling film thickness around a horizontal tube using a laser measurement technique[J]．Heat Transfer Engineering，2004，25(8)：28-34．
[17] WANG X F，HE M G，FAN H L，et al．Measurement of falling film thickness around a horizontal tube using laser-induced fluorescence technique[J]．Journal of Physics：Conference Series，2009，147(1)：175-180．
[18] 郭斌，李会雄，郭笃鹏．水平管外降膜流动液膜厚度的测量及分析[J]．工程热物理学报，2011，32(1)：71-74．
GUO B，LI H X，GUO D P．Measurement and analysis of the thickness distribution of falling liquid films around horizontal tubes[J]．Journal of Engineering Thermophysics，2011，32(1)：71-74．
[19] 吕凯，王小飞，张颖，等．水平蒸发管管间相邻液柱分离间距测量[J]．化工学报，2012，63(3)：740-745．
LV K，WANG X F，ZHANG Y，et al．Departure-site spacing for liquid columns falling between horizontal circular tubes[J]．CIESC Journal，2012，63(3)：740-745．
[20] CHEN X，SHEN S Q，WANG Y X，et al．Measurement on falling film thickness distribution around horizontal tube with laser-induced fluorescence technology[J]．International Journal of Heat & Mass Transfer，2015，89：707-713．
[21] LAZCANO-VéLIZ Y，SIQUEIROS J，JUáREZ-ROMERO D，et al．Analysis of effective wetting area of a horizontal generator for an absorption heat transformer[J]．Applied Thermal Engineering，2014，62(2)：845-849．
[22] Yoon J I，Phan T T，Moon C G，et al．Heat and mass transfer characteristics of a horizontal tube falling film absorber with small diameter tubes[J]．Heat and Mass Transfer，2008，44(4)：437-444．