欢迎访问过程工程学报, 今天是

›› 2012, Vol. 12 ›› Issue (1): 14-18.

• 流动与传递 • 上一篇    下一篇

立磨选粉机叶片参数的分析与优化设计

童聪 李双跃 綦海军 任朝富   

  1. 西南科技大学制造学院 西南科技大学制造学院 西南科技大学制造学院 西南科技大学制造学院
  • 收稿日期:2011-12-06 修回日期:2012-01-09 出版日期:2012-02-20 发布日期:2012-02-20
  • 通讯作者: 李双跃

Analysis and Optimization of Blade Parameters in Vertical Milling Classifier

TONG Cong LI Shuang-yue QI Hai-jun REN Chao-fu   

  1. College of Manufacturing Science and Engineering, Southwest University of Science and Technology College of Manufacturing Sci. and Eng., Southwest University of Science and Technology College of Manufacturing Sci. and Eng., Southwest University of Science and Technology College of Manufacturing Sci. and Eng., Southwest University of Science and Technology
  • Received:2011-12-06 Revised:2012-01-09 Online:2012-02-20 Published:2012-02-20
  • Contact: LI Shuang-yue

PDF

摘要： 通过构建不同叶片间距和安装倾角的立磨选粉机模型，采用CFD软件模拟分析了转子叶片间距与安装倾角对分级区速度场的影响及分级效率的变化规律. 对立磨选粉机转子进行了基于叶片间距及安装倾角的改造试验，结果表明，改造后的转子叶片数为48、安装倾角为5o的立磨选粉机产量比叶片数为72、安装倾角为0o的提高了0.5~1 t/h，且减小了循环负荷与能耗，降低了成品生产成本与设备制造成本.

关键词: 立磨选粉机, 叶片间距, 安装倾角, 速度场, 分级效率

Abstract: Models of vertical milling classifier with different rotor blade spacings and tilt angles of installation were built, and their effects on the velocity field and classification efficiency of classifier simulated by CFD. Structural transformation in the spacing and tilt angle of classifier was tested, and the result showed that after transformation, the production of vertical milling classifier with rotor blade number of 48 and installing tilt angle of 5o was increased by 0.5~1 t/h compared with that with the rotor blade number of 72 and installing tilt angle of 0o. And the cyclic loading and energy consumption were reduced and the cost of device and product was lowered.

Key words: vertical milling classifier, rotor blade spacing, tilt angle of installatio, velocity field, classification efficiency

中图分类号: