• 流动与传递 •

气淬高温熔渣颗粒运动和换热特性的数值分析

1. 1. 北京工业大学传热强化与过程节能教育部重点实验室，北京 100124 2. 北京工业大学传热与能源利用北京市重点实验室，北京 100124
• 收稿日期:2018-10-08 修回日期:2018-12-27 出版日期:2019-08-22 发布日期:2019-08-15
• 通讯作者: 王景甫 jfwang@bjut.edu.cn
• 基金资助:
国家重点基础研究发展规划(973计划)

Numerical analysis on dynamics and heat transfer progress of a granulated molten slag particle by gas

Yiming FAN1,2, Jingfu WANG1,2*

1. 1. Key Laboratory of Enhanced Heat Transfer and Energy Conservation, Ministry of Education, Beijing University of Technology, Beijing 100124, China 2. Key Laboratory of Heat Transfer and Energy Conversion, Beijing Municipality, Beijing University of Technology, Beijing 100124, China
• Received:2018-10-08 Revised:2018-12-27 Online:2019-08-22 Published:2019-08-15
• Contact: Jingfu Wang jfwang@bjut.edu.cn

Abstract: In order to investigate the dynamics and heat transfer progress and characteristics of granulated molten blast furnace slag by blast air, a mathematical model was established and solved through the fourth order Runge?Kutta algorithm, the calculation program was compiled by FORTRAN. Considering that the efficiency of air cooling was low, a method of spray cooling was presented to improve the cooling rate. And the effects of varied particle size on movement and cooling were also researched. The variations of main thermal physical properties of slag and air with temperature were taken into account during the calculation progress that in order to enhance reliability of the study. And the temperature recovery method was used to deal with the solidification of molten slag. The results indicated that the motion trail of the slag particle was parabolic curve after granulation, and velocity of the slag particle was firstly increased and then decreased by the influence of quenching gas during the flight, the cooling rate of slag particle was mainly influenced by the convective heat transfer coefficient which varied with the relative velocity of blast air and slag particle. Meanwhile, the cooling rate of slag particle was significantly improved due to the addition of spray because of the evaporation of droplet and enhancement of convective heat transfer. The final temperature of the slag particle reduced with the decreasing particle size, which meaned that the smaller particle size can make better cooling effect. And the motion parameters of the particle which had smaller size was more susceptible to the blast air. Generally, the smaller size of slag particle, the better of blast air cooling, and the smaller the space needed for granulation.