欢迎访问过程工程学报, 今天是

›› 2006, Vol. 6 ›› Issue (5): 768-772.

• 过程与工艺 • 上一篇    下一篇

氢氧化铝晶体颗粒强度的数值模拟分析

叶露升,陈启元,尹周澜,花书贵,李旺兴   

  1. 中南大学化学化工学院冶金及应用物理化学研究所
  • 出版日期:2006-10-20 发布日期:2006-10-20

Finite Element Analysis on Gibbsite Strength

YE Lu-sheng,CHEN Qi-yuan,YIN Zhou-lan,HUA Shu-gui,LI Wang-xing   

  1. College of Chemistry and Chemical Engineering, Central South University
  • Online:2006-10-20 Published:2006-10-20

摘要: 利用有限元方法对氢氧化铝晶体叠合形成的氢氧化铝颗粒进行了静力分析,得到了氢氧化铝晶体叠合角度与叠合形成的氢氧化铝颗粒强度的关系,计算了叠合氢氧化铝晶体尺寸与氢氧化铝颗粒强度变化之间的规律. 研究发现:(1) 当氢氧化铝晶体间叠合角度在60o~80o时,氢氧化铝颗粒所受应力最大,强度最小;(2) 叠合的氢氧化铝晶体尺寸较小(约5 mm)时,氢氧化铝颗粒所受应力较小,强度较大;(3) 叠合的氢氧化铝晶体尺寸较大(20~40 mm)时,叠合晶体尺寸越大,氢氧化铝颗粒所受应力越大,强度越小;(4) 大晶体间镶嵌有细小晶体的叠合方式,形成的氢氧化铝颗粒强度有明显优势.

关键词: 氢氧化铝, 晶体叠合, 颗粒强度, 有限元分析

Abstract: The finite element analysis method is applied to study the relationships between the gibbsite crystal overlapped angle and the strength of gibbsite particles. The regularity of the particle size of gibbsite with the strength is calculated. The results show that: (1) The strength of gibbsite is weak when overlapped angle of the crystals is between 60o~80o; (2) When the gibbsite crystals are smaller (about 5 mm), the gibbsite strength becomes better; (3) When the gibbsite crystals are larger (20~40 mm), the gibbsite strength is weaker; (4) The strength of gibbsite particle with different crystal sizes has obvious advantages.

Key words: gibbsite, crystal overlapping, particle strength, finite element analysis