1. School of Mechanical Engineering, Hefei University of Technology, Hefei, Anhui 230009, China
2. School of Automobile and Transportation Engineering, Hefei University of Technology, Hefei, Anhui 230009, China
Abstract:Activated carbon was prepared from the mix of sycamore tree sawdust and polypropylene plastics by activation of K2CO3. Based on the central composite design (CCD) of response surface method (RSM), the preparation process was optimized, for the purpose of the highest methylene blue adsorption with higher iodine number. The optimum conditions were plastic content of 19wt%, K2CO3/sawdust mass ratio of 1.73, activation temperature of 958℃, and activation time of 91 min. The adsorption capacities of iodine and methylene blue were 1320.97 and 471.95 mg/g, with the predictive errors of 1.64% and 8.56%, respectively, which proves the high credibility of second-order model. The analysis of variance showed that the salt/sawdust ratio, activation temperature, and activation time were significant factors influencing the iodine adsorption capacity of activated carbon, which had a promoting effect, while plastic percentage had an inhibitory effect on the iodine adsorption capacity of activated carbon. The activation temperature and activation time had significant effects on the adsorption capacity of methylene blue on activated carbon, and had a promoting effect on the percentege of plastic. The salt/sowdust was a non-significant factor and had an inhibitory effect. The specific surface area, total pore volume and average pore size of the optimum sample were 1916.10 m2/g, 1.12 cm3/g, and 2.63 nm. Among them, the mesopore volume was 0.75 cm3/g, and the mesoporosity reached 70.10%. Compared with the activated carbon prepared by single factor optimization experiments, the specific surface area was increased by 454.11 m2/g. FT-IR analysis showed that the functional groups of the activated carbon prepared by the two optimization experiments did not change basically, and the increase of the activated carbon methylene blue adsorption was mainly due to the increase in specific surface area. The results suggested that the activated carbon optimized by response surface method has good absorptive property of macromolecules.
马培勇 王田 武晋州 邢献军 张贤文. 响应面法优化制备塑料-锯末活性炭[J]. 过程工程学报, 2019, 19(2): 377-386.
Peiyong MA Tian WANG Jinzhou WU Xianjun XING Xianwen ZHANG. Optimization of activated carbon preparation from sawdust and plastics using response surface method. Chin. J. Process Eng., 2019, 19(2): 377-386.
[1] Sircar S, Golden T C, Rao M B. Activated carbon for gas separation and storage [J]. Carbon, 1996, 34(1):1-12.
[2] MustafaSoylak, LatifElci, MehmetDogan. A Sorbent Extraction Procedure for the Preconcentration of Gold, Silver and Palladium on an Activated Carbon Column[J]. Analytical Letters, 2000, 33(3):513-525.
[3] Marsh H. Introduction to carbon science[J]. Stoneham, MA (USA); Butterworth Publishers, 1989.
[4] Jia Z, Xu J, Xu J, et al. Enhancement of Au/AC acetylene hydrochlorination catalyst activity and stability via nitrogen-modified activated carbon support [J]. Chemical Engineering Journal, 2015, 262:1152-1160.
[5] Watanabe H, Asano S, Fujita S, et al. Nitrogen-Doped, Metal-Free Activated Carbon Catalysts for Aerobic Oxidation of Alcohols [J]. Acs Catalysis, 2015, 5(5):2886-2894.
[6] Shin H D, Agostini M, Belharouak I, et al. High-power lithium polysulfide-carbon battery [J]. Carbon, 2016, 96:125-130.
[7] Hou J, Cao C, Idrees F, et al. Hierarchical porous nitrogen-doped carbon nanosheets derived from silk for ultrahigh-capacity battery anodes and supercapacitors[J]. Acs Nano, 2015, 9(3):2556.
[8] Hameed B H, Tan I A W, Ahmad A L. Optimization of basic dye removal by oil palm fibre-based activated carbon using response surface methodology.[J].Journal of Hazardous Materials , 2008 , 158(2–3):324-332.
[9] 陈文婷, 冉启成, 蔡献宗,等. K2CO3活化空心莲子草制备活性炭及表征[J]. 化工学报, 2016, 67(s1):353-358.
Chen W, Ran Q, Cai X, et al. Preparation and characterization of activated carbon from Alternanthera philoxeroides by K_2CO_3 activation[J]. Ciesc Journal, 2016, 67(s1):353-358.
[10] 谢新苹, 孟中磊, 蒋剑春,等. 磷酸活化桉木屑制备活性炭的影响因素及表征[J]. 东北林业大学学报, 2013, 41(4):116-119.
Xie X, Meng Z, Jiang J, et al. Preparation and Characterization of Activated Carbon from Eucalyptus Sawdust with Phosphoric Acid[J]. Journal of Northeast Forestry University, 2013, 41(4):116-119.
[11] 刘肖强, 李奕怀, 张素娜,等. 酚醛树脂制备活性炭的工艺[J]. 上海第二工业大学学报, 2016, 33(2):107-111.
[12] 马培勇, 武晋州, 张贤文,等. 聚丙烯塑料-锯末干混合制备高介孔率柱状活性炭[J]. 环境科学学报, 2018(2).
Peiyong M A, Jinzhou W U, Zhang X, et al. Preparation of high mesoporous granular activated carbon with polypropylene and sawdust via dry mix method[J]. Acta Scientiae Circumstantiae, 2018(2)..
[13] S. Y. Chen, P. L. Lin. Optimization of operating parameters for the metal bioleaching process of contaminated soil [J]. Separation and Purification Technology, 2010, 71(2): 178-185.
[14] Musia, E. Cibis, W. Rymowicz. Designing a process of kaolin bleaching in an oxalic acid enriched medium by Aspergillus niger cultivated on biodiesel-derived waste composed of glycerol and fatty acids [J]. Applied Clay Science, 2011, 52(3): 277-284
[15] Saeed M O, Azizli K, Isa M H, et al. Application of CCD in RSM to obtain optimize treatment of POME using Fenton oxidation process[J]. Journal of Water Process Engineering, 2014, 8(2):e7-e16.
[16] Liyana-Pathirana C, Shahidi F. Optimization of extraction of phenolic compounds from wheat using response surface methodology[J]. Food Chemistry, 2005, 93(1):47-56.
[17] Quanhong L, Caili F. Application of response surface methodology for extraction optimization of germinant pumpkin seeds protein.[J]. Food Chemistry, 2005, 92(4):701-706.
[18] Z. A. Ghani, M. A. M. Ishak, K. Ismail. Direct liquefaction of Mukah Balingian low-rank Malaysian coal: optimization using response surface methodology [J]. Asia-Pacific J. Chem. Eng., 2010, 6(4): 581-588.
[19] M. A. Jamaluddin, K. Ismail, M. A. Mohd Ishak, Z. Ab Ghani, M. F. Abdullah, M. T. Safian, et al. Microwave-assisted pyrolysis of palm kernel shell: Optimization using response surface methodology (RSM) [J]. Renewable Energy, 2013, 55(4): 357-365.
[20] N. B. Azmi, M. J. K. Bashir, S. Sethupathi. L. J. Wei, N. C. Aun. Stabilized landfill leachate treatment by sugarcane bagasse derived activated carbon for removal of color, COD and NH3-N – Optimization of preparation conditions by RSM [J]. J. Environ. Chem. Eng., 2014, 3(4): 1287-1294.
[21] Shieh C J, Liao H F, Lee C C. Optimization of lipase-catalyzed biodiesel by response surface methodology[J]. Bioresource Technology, 2003, 88(2):103-106.
[22] 刘义彬,马晓波,陈德珍,等. 废塑料典型组分共热解特性及动力学分析[J].中国电机工程学报, 2010,30(23):56-61,
Liu Y B, Ma X B, Chen D Z, et al. Copyrolysis characteristics and kinetic analysis of typical constituents of plastic wastes[J]. Proceedings of the Csee, 2010, 30(23):56-61.
[23] 黄学敏, 苏欣, 杨全. 污泥活性炭固定床吸附甲苯[J]. 环境工程学报,2013,7(3):1085-1090.
Huang X. Adsorption of toluene by fixed sludge-based activated carbon bed[J]. Chinese Journal of Environmental Engineering, 2013, 7(3):1085-1090.
[24] Osório N M, Ferreira-Dias S, Gusm?o J H, et al. Response surface modelling of the production of ω-3 polyunsaturated fatty acids-enriched fats by a commercial immobilized lipase[J]. Journal of Molecular Catalysis B Enzymatic, 2001, 11(4–6):677-686.
[25] Ghani Z A, Yusoff M S, Zaman N Q, et al. Optimization of preparation conditions for activated carbon from banana pseudo-stem using response surface methodology on removal of color and COD from landfill leachate.[J]. Waste Management, 2017, 62:177-187.
[26] Junior O P, Cazetta A L, Gomes R C, et al. Synthesis of ZnCl 2 -activated carbon from macadamia nut endocarp ( Macadamia integrifolia ) by microwave-assisted pyrolysis: Optimization using RSM and methylene blue adsorption[J]. Journal of Analytical & Applied Pyrolysis, 2014, 105(5):166-176.
[27] Bedin K C, Martins A C, Cazetta A L, et al. KOH-activated carbon prepared from sucrose spherical carbon: Adsorption equilibrium, kinetic and thermodynamic studies for Methylene Blue removal[J]. Chemical Engineering Journal, 2016, 286: 476-484.
[28] 金彦任,黄振兴. 吸附与孔径分布[M]. 北京:国防工业出版社, 2015, 87-91
[29] Zuo S, Yang J, Liu J, et al. Significance of the carbonization of volatile pyrolytic products on the properties of activated carbons from phosphoric acid activation of lignocellulosic material[J]. Fuel Processing Technology, 2009, 90(7–8):994-1001