Welcome to visit The Chinese Journal of Process Engineering, Today is

›› 2010, Vol. 10 ›› Issue (5): 874-878.

• 流动与传递 • Previous Articles     Next Articles

Measurement and Analysis of Vibration Behavior of Ceramic Filter Element in Operating Conditions

WU Xiao-lin XIAO Wang JI Zhong-li   

  1. Faculty of Chemical Science and Engineering, China University of Petroleum Faculty of Chemical Science and Engineering, China University of Petroleum College of Mechanical and Transportation Engineering, China University of Petroleum
  • Received:2010-08-16 Revised:2010-10-13 Online:2010-10-20 Published:2010-10-20
  • Contact: WU Xiao-lin

陶瓷滤管运行过程中的振动特性测定与分析

吴小林 肖旺 姬忠礼   

  1. 中国石油大学化工学院 中国石油大学化工学院 中国石油大学机械与储运工程学院
  • 通讯作者: 吴小林

PDF

Abstract: In order to analyze the reason of rupture deformation of ceramic filter element, the vibration amplitude of ceramic filter element was measured by eddy current displacement sensor, and the influences of operational parameters on its vibration amplitude were measured. The experimental results showed that gas blowback would lead to radial displacement for the ceramic filter element, which maybe cause rupture deformation for ceramic filter element. In addition to, the influence of pressure of gas blowback on the vibration amplitude of ceramic filter element was obvious, if the pressure increased from 0.3 to 0.5 MPa, the displacement increase would reach 40%. However, the influence of filtration rate and pulse width on vibration amplitude can be ignored.

Key words: ceramic filter element, pulse cleaning, vibration amplitude

摘要： 为分析实际生产中陶瓷滤管断裂的原因，利用电涡流位移传感器测定了陶瓷滤管在气体反吹时的振动，并测量了操作参数对陶瓷滤管振动的影响. 结果表明，陶瓷滤管在反吹时会产生径向位移，由于陶瓷滤管抗形变能力弱，可能会导致滤管发生断裂；另外，改变反吹压力对滤管振幅影响较大，反吹压力从0.3 MPa升至0.5 MPa时，滤管的振幅增加约40%；而改变过滤速度、脉冲宽度对滤管振幅影响较小，但会影响滤管振动的持续时间.

关键词: 陶瓷滤管, 脉冲反吹, 振动测试

CLC Number: