欢迎访问过程工程学报, 今天是

过程工程学报 ›› 2019, Vol. 19 ›› Issue (6): 1135-1142.DOI: 10.12034/j.issn.1009-606X.219158

• 过程与工艺 • 上一篇    下一篇

电喷雾质谱法示踪钨回收过程离子的转化路径

蔺淑洁1,2, 温嘉玮1, 曹宏斌1, 宁朋歌1*, 张 懿1   

  1. 1. 北京市过程污染控制工程技术研究中心,中国科学院过程工程研究所湿法冶金清洁生产技术国家工程实验室,北京 100190 2. 中国科学院大学化学工程学院,北京 100049
  • 收稿日期:2019-03-18 修回日期:2019-04-07 出版日期:2019-12-22 发布日期:2019-12-22
  • 通讯作者: 宁朋歌 pgning@ipe.ac.cn
  • 基金资助:
    杰出青年基金;青促会基金

Tracking transformation pathway of tungsten recovery process by electrospray ionization time-of-flight mass spectrometry

Shujie LIN1,2, Jiawei WEN1, Hongbin CAO1, Pengge NING1*, Yi ZHANG1   

  1. 1. Beijing Engineering Research Center of Process Pollution Control, National Engineering Laboratory for Hydrometallurgical Cleaner Production & Technology, Institute of Process Engineering, Chinese Academy of Sciences, Beijing 100190, China 2. School of Chemical Engineering, University of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2019-03-18 Revised:2019-04-07 Online:2019-12-22 Published:2019-12-22

摘要: 将环隙式离心萃取器(ACCs)与电喷雾飞行时间质谱(ESI-TOF-MS)相结合,在线监测了回收过程中的钨萃取行为(宏观)和钨形态的转化路径(微观),发现宏观萃取反应和微观离子形态转化同时发生并相互补充。伯胺N1923萃取钨在144 s内即可达到萃取平衡,萃取率高达98%以上,同时,酸钨比n(H)/n(W)是一个关键变量,当酸钨比n(H)/n(W)=2.4时,全流程钨回收率超过93%。最后,得到了基于钨形态监测的萃取机理,同时,减少原料液中W1含量,增加W10含量,可有效提高钨回收效率。

关键词: 钨, 伯胺N1923, 形态转化, ESI-TOF-MS

Abstract: Tungsten is an important rare metal, which is widely used in the fields of national defense, chemical industry, electronics and metallurgy. Solvent extraction has been widely used for tungsten recovery because of its simple operation, good continuity and high recovery rate. Previous researches have always focused on the development of new extractants while ignoring the role of tungsten ion morphology in the extraction process. In fact, ion morphology will affect the way of combining with the extractant and the extraction process. Therefore, in-depth study of ion morphology in the extraction process can better understand the extraction mechanism of tungsten, and thus provide a basis for the separation of tungsten and molybdenum. In this study, annular centrifugal contactors (ACCs) were combined with electrospray ionization time-of-flight mass spectrometry (ESI-TOF-MS) to study the transformation pathway of tungsten species in the recovery process by online monitoring method. It was found that the extraction of tungsten by primary amine N1923 was very fast and effective. Within 144 s, more than 98% of the tungsten could be extracted into the organic phase. At the same time, n(H)/n(W) was a key variable. When the acid ratio was 2.4, the whole tungsten recovery rate exceeded 93%. Finally, the extraction mechanism based on tungsten morphology monitoring was obtained. The macroscopic extraction reaction and the micro-ion exchange reaction occurred simultaneously and complemented each other. As the initial pH decreased, W2, W6 and W10 became active forms in sequence and were preferentially extracted into the organic phase, respectively. In addition, W10 was more active than any other species during the whole process. W1 was an inactive substance that only participated in the tungsten ion balance reaction to adjust the tungsten form and pH. As a result, reducing W1 and increasing W10 as much as possible would be conducive to improve tungsten extraction efficiency in solution.

Key words: tungsten recovery, primary amine N1923, tungsten transformation pathway, ESI-TOF-MS